I-7530A-MR_DESCRIPTION.html
The I-7530A-MR Modbus RTU to CAN converter is helpful for data exchanging between the RS-232/485/422 devices and the CAN devices. It supports three communication modes: "Normal", "Modbus RTU", "Pair-connection".
I-7530A-MR.html
| CAN Interface
|
| Controller
|
Microprocessor inside with 96 MHz
|
| Transceiver
|
NXP 82C250
|
| Connector
|
9-pin male D-Sub (CAN_L, CAN_H, N/A for others)
|
| Channels
|
1
|
| Baud Rate (bps)
|
10 k, 20 k, 50 k, 100 k, 125 k, 250 k, 500 k, 800 k and 1 M (allow
user-defined baud rate)
|
| Protection
|
3000VDCpower protection and 3750Vrms photo-couple isolation on CAN
side
|
| Terminator Resistor
|
Selectable 120O terminator resistor by jumper
|
| Support Protocol
|
ISO-11898-2, CAN 2.0A and CAN 2.0B
|
| Pin Assignment
|
C.I.A. DS-102 (CAN_H=7, CAN_L=2)
|
| UART Interface
|
| Connector
|
14-pin terminal connector
|
| COM
|
RS-232 : TxD, RxD, GND; RS-422 : TxD+, TxD-, RxD+, RxD-; RS-485 :
DATA+, DATA-
|
| Baud Rate (bps)
|
300,600,1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200, 230400
|
| Protection
|
3000VDCpower protection and 2500Vrms photo-couple isolation on UART
side
|
| LED
|
| Round LED
|
PWR/CAN/UART
|
| Power
|
| Power supply
|
+10 ~ +30 VDC
|
| Power Consumption
|
1.5 W
|
| Dip Switch
|
Init (Firmware Update, Module Configuration)/Normal (Firmware
Operation)
|
| Mechanism
|
| Installation
|
DIN-Rail
|
| Dimensions
|
72mm x 118mm x 35mm (W x L x H)
|
| Environment
|
| Operating Temperature
|
-25 ~ 75 ?
|
| Storage Temperature
|
-30 ~ 80 ?
|
| Humidity
|
10 ~ 90% RH, non-condensing
|
|
